Call 330-241-5386 Today

Tune-Up Electronic Ignition

• Replace spark plugs
• Adjust engine timing As required
• Adjust carb idle speed as required
• Visually inspect emmission-control related devices
• Visually inspect plug wires
• Visually inspect distributor cap and rotor, when accessible
• Visually inspect plug wires

Transmission Fluid Flush

• Road test for engine performance, transmission operation and shift patterns
• Flush transmission cooler and cooler line
• Flush transmission valve body
• Flush transmission torque converter
• Thoroughly clean all internal parts
• Flush out all contaminated transmission fluid and replace with clean fluid
• Install transmission additive to revitalize transmission seals and O-rings
• Road test vehicle for proper transmission operation

Brake fluid flush

• Check brake fluid for contamination and moisture
• Inspect all hydraulic lines and hoses
• Inspect calipers and wheel cylinders
• Inspect master cylinder and caps
• Clean dirt and old fluid out of master cylinder
• Flush old fluid out of master cylinder, calipers and wheel cylinders until clean
• Add new brake fluid to master cylinder, as needed
• Road test vehicle for proper brake operation

Brake inspection and service

• Visually inspect hydraulic system for leak and condition
• Remove all wheels and inspect brake lining, brake hardware and wheel cylinders
• Remove brake dust and deglaze brake shoes
• Adjust brakes
• Adjust parking brake
• Lubricate backing plate and adjust hardware

Air Conditioning

• Test system for proper Freon
• Test Freon for moisture contamination
• Test Freon for air contamination
• Clean condensor fins as required
• Inspect and adjust A/C compressor drive belt
• Performance test A/C operation
• Inspect all visible A/C components for leaks and add Freon dye, as needed
• Test antifreeze for proper mix

Cooling System Power Flush

• Pressure test cooling system for leaks
• Flush engine, radiator and heater core in both directions
• Bring anti-freeze temperatures to -35 degrees
• Balance coolant PH level to between 9.8 and 10.5
• Visually inspect radiator cooling fan for proper operation
• Visually inspect heater operation

Power Steering Fluid Flush

• Road test for power steering operation
• Inspect system for leaks
• Flush power steering lines
• Flush power steering pump
• Flush power steering rack and pinion, and/or gear box
• Thoroughly clean all internal parts
• Flush out all contaminated power steering fluid and replace with clean fluid
• Install power steering additive to revitalize seals and O-rings

Electrical System Analysis

• Inspect battery connections
• Charge battery to full capacity
• Load test battery and record readings
• Inspect alternator belt and adjust, as required
• Perform alternator output test and record readings
• Perform starter draw test and record readings
• Perform test for draw on electrical system and record finidings
• Replace battery, if required

Fuel Injection Serivce

• Clean fuel injectors
• Clean ISC/ASC motor, as required
• Clean throttle body air intake
• Visually inspect fuel line and fuel rails
• Pressure test fuel pump
• Test and visually inpsect fuel pump, pressure regulator, vacuum line and connections
• Decarbonize intake manifold
• Decarbonize intake and exhaust valves
• Decarbonize combustion chamber and pistons
• Test exhaust emmission

Wheel Alignment

• Inspect suspension components for wear
• Adjust caster and camber, if provided my manufacturer
• Adjust toe-in
• Center steering wheel while adjusting toe-in

Thrust Alignment:

• Same as above plus compensate for rear wheel tracking

Four Wheel Alignment:

• Sane as above plus set rear wheel camber and toe-in, as provided by manufacturer